Preparation of aspirin

Use this product up to four times a day, especially after a bowel movement. What is the yield of dry aspirin? Crush about mg of dry aspirin with a spatula against the walls of a mL beaker.

Drug information contained herein may be time sensitive. Remember that when a solution becomes cloudy, that is a solid forming and this would be the crystals of aspirin you desire.

Basic Organic Chemistry Laboratory Manual. Perhaps, the sample was not weighed properly or it was weighed when still wet.

Synthesis and Characterization of Aspirin

Cool the mixture in an ice bath until recrystallization is complete. This has been a fairly simple investigation into the chemistry of acetylsalicylic acid. Caution students about reagent hazards. Normally the hydrolysis is driven to the right Preparation of aspirin low pH, as well as by losses of HOAc to the air.

There was a problem providing the content you requested

Then, cool the mixture and let the crystals form, even though not all the solid may have gone solution. Acetic anhydride will be used in this experiment so that when ester is formed, water is not produced.

What Is the Chemical Equation for the Synthesis of Aspirin?

To prepare an aspirin solution, dissolve 0. Phosphoric acid was used as a catalyst. After aspirin synthesis was complete, the aspirin was analyzed using both IR and NMR spectrometers in order to determine the hydrogen atoms and organic functional groups present in the synthesized aspirin and to verify the overall identity of the aspirin.

Determine the melting point of your purified salicylic acid m. The more "acid" part of salicylic acid in other words, its own -COOH group is not part of the ester reaction, even though its presence may cause confusion to students.

Once all of the liquid is gone from the crucible, the solid should be rinsed with a solvent that will not dissolve the solid in order to wash out and trapped impurities. Another laboratory procedure used in this procedure is reading and recording liquid volumes. For example, if your solid dissolves easily in ethanol, but not well in water check the solubilities abovefirst dissolve your solid in as little ethanol as possible, perhaps at a slightly elevated temperature.

Purification is needed to eliminate any salicylic acid and acetic anhydride that did not react, as well as the acetic acid product and phosphoric acid.

A few concepts are understood to be known in this experiment. In differentiating salicylic acid to acetylsalicylic acid, ferric chloride was used because compounds containing phenol group will generate a colored complex such as blue red green or purple.

By calculating the theoretical yield based on the original amount of Salicylic acid, one could determine the actual yield percentage of the reaction. Methyl salicylate also has a pleasant odor, and it is used as an extract for flavoring purposes. Preparation H Overdose If you suspect an overdose, you should contact a poison control center or emergency room immediately.

There are only three types of compounds which have an oxygen located between two carbons.

Aspirin: Pharmacology and Clinical Applications

Scientists never really understood the inner workings of the drug however. The mechanism of the reaction is: Sodium salicylate was not often popular though, as it has a habit of irritating the stomach. Does enteric-coated aspirin result in a lower incidence of gastrointestinal complications compared to normal aspirin?

During this time, the solid should dissolve completely.

Preparation H

The two different functional groups on the aromatic ring are utilized in this lab.Exercise 11 Synthesis of Aspirin (Acetylsalicylic Acid from Salicylic Acid) Sharmaine S. Bungabong Group 2 5L I. INTRODUCTION Organic synthesis is an important aspect in the industry of organic chemistry.

This aspect of organic chemistry has contributed much to the knowledge there is regarding the. Aspirin, also known as acetylsalicylic acid (ASA), is a medication used to treat pain, fever, or inflammation. Specific inflammatory conditions in which aspirin is used include Kawasaki disease, pericarditis, and rheumatic fever.

Aspirin Synthesis and Analysis

Aspirin given shortly after a heart attack decreases the risk of death. Esterification • The synthesis of aspirin is an esterification reaction.

• Esterification is the general name for a chemical reaction in which two chemicals. To prepare aspirin, salicylic acid is reacted with an excess of acetic anhydride.

A small amount of a strong acid is used as a catalyst which speeds up the reaction. In conclusion, an average daily dose of aspirin of mg with a coated preparation seems more likely to confer favorable preventive effects on death and cancer, with higher doses more appealing for CVD prevention and lower doses better tolerated.

EXPERIMENT A PREPARATION OF ASPIRIN Abstract This report gives a detailed account of the experimental preparation of aspirin in a laboratory environment as well as some basic industrial background on the product.

It also contains information about safety precautions put in place to ensure the safety of the team who carried out the experiment.

Download
Preparation of aspirin
Rated 4/5 based on 8 review